Categories

New products

50W Camper Kit

50W Camper Kit

317,00 € 422,67 €
Limited special offer
Battery 100Ah 12V Deep Cycle Prime

Battery 100Ah 12V Deep Cycle Prime

159,00 € 227,14 €
Limited special offer

EpSolar controller MPPT 12/24V - 10A

New product

Prezzo: 79,00 € + IVA 10%

Charge regulator 10A with Maximum Power Point Tracking MPPT an display It charges up to 30% more then traditional PWM charge regulators

More details

- +

 
More info

The TRACER 1210A is a charge controller with MPPT technology (Maximum Power Point Tracking), for use in photovoltaic systems. Through the use of MPPT technology, Tracer can increase charge current up to 30% or more compared to conventional controllers. The sophisticated charging three-phase system can be configured to optimize the charging parameters in accordance with the technical specifications of the battery. The controller is protected against voltage spikes, over temperature, over current, reverse polarity.

The charging voltage control takes place in MPPT, combined with a multi-phase control system. This ensures greater efficiency and battery life. The MPPT control is implemented thanks to the MOSFET power transistors, which are turned on and off in high frequency PWM to control the charging voltage in a precise manner.

This type of charge controller is equipped with display which has the purpose to show the status of the controller work and of the accessories connected to it (panels and accumulators). In addition to this function also it carries out maintenance of the battery is avoiding the overhead that underdischarging. These functions are automatically performed by the charge controller on the basis of the threshold voltages which are respectively HVD (maximum disconnect voltage) and LVD (minimum voltage of disconnection). In this way it gives the opportunity to accumulators to remain more efficient and longer in time.

These disconnection processes, automatically performed by the charge controller, are based on an automatically calculated parameter and maintained by the same regulator, ie the SOC, ie the state of battery charge.

This charge controller, for the calculation of the SOC, uses an integrated circuit capable of cutting edge calculate with great precision. The SOC is a very important parameter on which they are based protections for overload and undershooting. An additional parameter based on the SOC is the LVR (reconnection of load voltage). Leveraging this parameter, the controller can understand when accumulators are quite loads can be reconnected to the load (as with LVD protection accumulators may be disconnected from the load).

    
Automatic voltage selection (12 or 24V)
    
MPPT technology
    
High tracking efficiency not lower than 99%
    
conversion peak of 98%
    
tracking speed ultra-fast
    
Recognition and precise MPP tracking
    
Multifunction LCD display for system information
    
Battery type and the user-programmable load control
    
Three charging mode with PWM output
    
RS485 port with MODBUS standard
    
Fully programmable from PC with dedicated software or MT-50 Remote Display (Optional)
    
electrical protection: overload, short circuit, overload the battery, reverse polarity, overheating

Model


TRACER-1210A

Nominal system voltage (V) - 12 or 24

Maximum current panel -10A

max battery voltage (V) - 36

battery voltage range 8-32

Maximum consumption (mA) <16

Maximum PV input voltage (V) 100VOC

Maximum input power PV 12V / 130W - 24V / 260W

overload protection 35A

Operating temperature (C) from -25 to + 45

Type of charge MPPT (4 stages)

Degree of protection IP 30

Dimensions (mm) 172x139x44 mm

Weight kg) 0.6


 

17 other products in the same category:

Recently Viewed

Menu

Top